This is our first product that we bottled called Uni-Seal. This product will seal punctured holes up to 8mm comfortably. You can not insert this product through a valve, therefore you need to remove the inner valve with the valve key supplied with the bottle. After installation you need an air source to inflate your wheel to the correct pressure and you are ready to go.

1. Shake Bottle well.  2.Turn wheel to 4 or 8 o’clock
position.  3. Remove inner valve from tyre with valve
spanner supplied.  4.Cut nozzle off at indicated
position.  5.Screw nozzle over valve and insert correct
amount of SLUDGE TYRE SEALANT. For valves difficult
to reach, use a 8mm tube.  6.Remove bottle and
grease inner valve before replacing.  8.Inflate tyre
to correct pressure and keep inflated at
manufacturers specifications.

QUANTITY OF SLUDGE REQUIRED PER WHEEL

 Mountain bike, wheelbarrow, wheelchair.......100ml
 Motorbike, small car, golf car, trailers..........200ml
 Saloon car, pickup truck, 4x4 trucks...........400ml
 Busses and trucks...................................600ml

IMPORTANT

Shake bottle well & grease inner valve before
replacing.   Make sure that tyre is turned a few
times so that SLUDGE SEALANT can reach the
hole to seal it permanently.